Introduction: Wet Sounds™ Syndicate Series Marine Amplifiers represent the
highest performing marine audio amplifiers on the market.
With advanced technologies like Class H and Class G/H power
supplies for high power with less current draw and less heat.
Microprocessor controlled forced fan cooling, full polished
stainless steel chassis for true marine grade, conformal coated
PCB boards, advanced microprocessor protection circuit for
under/over voltage, thermal overload and short protection,
flexible crossovers for both high pass and low pass use on full
range models, and matched power ratings to drive all Wet Sounds™ speakers.
Main Features:
The SYN4 is a high powered 4 channel class H amplifier. It has the ability to run full range, high pass or low pass. With the SYN4, you can run your in boat speakers only, your in boat speakers and a subwoofer, in boat speakers and tower speakers, tower speakers and a subwoofer, subwoofers only or tower speakers only.
Specifications:
SYN 4: Full Range 4 Channel Class H Amplifier
Stereo @ 4 Ohms
125 x 4 watts RMS
Stereo @ 2 Ohms
200 x 4 watts RMS
Mono @ 4 Ohms
400 x 2 watts RMS
s/n ratio @ 1 watt
> 89 dB
Frequency Response
10 Hz - 50 KHz
Transient Distortion
< .01% @ 4 Ohms
Input Sensitivity
0.6 V - 6.0 V
Input Impedence
20K Ohms
Bass Boost
+15 dB @ 45 Hz
Front Crossover
HP/LP 55 Hz - 550 Hz
Rear Crossover
HP/LP 55 Hz - 5.5 KHz
Dimensions Inches ( L x W x H )
13" x 8" x 2 3/8"
Recommended Configurations:
In Boat Speakers: - 2 to 4 pairs of XS-650 in boat speakers. Power: 125 x 4 or 200 x 4
In Boat Speakers and Subwoofer: - 1 to 2 pairs of XS-650 and a single subwoofer XS-10FA or XS-12 bridged at 4 ohms. Power: 125 or 200 x 2 and 400 x 1.
In Boat Speakers and Tower Speakers: - 1 to 2 pairs of XS-650 and a pair of PRO 60’s. Power: 125 or 200 x 2 and 125 x 2
Tower Speakers and Subwoofer: - 1 pair of PRO 60’s and a single subwoofer XS-10FA or XS-12 bridged at 4 ohms. Power: 125 x 2 and 400 x 1.
Subwoofers: - 2 XS-10FA’s or XS-12 subwoofers bridged at 4 ohms. Power: 400 x 2.
Tower Speakers: - 1 pair of PRO 485 bridged. Power: 400 x 2.
- 2 pairs of Pro 60’s. Power: 125 x 4
- 3-Some tower system. Pair of PRO 60’s or PRO 80's on channels 1 and 2 and single PRO 485 bridged at 4 ohms on channels 3 and 4. Power: 125 x2 and 400 x 1.
- Double Up tower system. Power: 125 x 4.
